Depreciation on plastic mould - two wheeler manufacturer - it is ...

Income Tax

October 19, 2016

Depreciation on plastic mould - two wheeler manufacturer - it is immaterial whether the plastic /rubber moulds were used in the factory premises of the assessee or vendors - depreciation allowed at higher rate - AT

View Source

← Previous Next →

Depreciation on plastic mould - two wheeler manufacturer - it is ...

Income Tax

October 19, 2016

You may also like:

Depreciation on moulds -Factory of the assessee was plastic goods factory. The moulds used for manufacturing such goods, therefore, qualify for higher rate of depreciation - HC

Moulds manufactured and captively used - the exemption for captive consumption cannot be denied if the capital goods are used within the factory or production - AT

GST - Valuation - job work - amortization of cost of moulds and dies etc. - if the contract between OEM and component manufacturer was for supply of components made by...

Clandestine manufacture and removal - plastic molded chairs - burden of proof to establish that there was clandestine manufacture - seizure of the pen drive -...

Depreciation on two wheeler vehicles and Car purchased in the name of directors - beneficial owner of asset - only registration in the name of director is not sufficient...

Denial of Cenvat credit on moulds - whether moulds are in possession of the appellant? - Since, moulds, in this case, have not been removed from the factory by the...

Classification of goods - rate of tax - agricultural implements namely latex collection cup, made of plastic, used exclusively for collection of rubber latex, an...

GST - Valuation - job work - amortization of cost of moulds and dies etc. - while calculating the value of the supply made by the component manufacturer, the value of...

Classification of goods - rate of tax - Two wheeler seat covers - the Two wheeler seat covers are specifically covered under CTH 87149990 and are taxable (@ 14% CGST +...

CENVAT Credit - though the tools and moulds purchased by them were continue in use for manufacture of excisable automobile components however same has been shown as sold...

Quick Updates: