Iron and Steel - Classification of flat rolled products - Clarification regarding

X X   X X   Extracts   X X   X X

→ Full Text of the Document

X X   X X   Extracts   X X   X X

..... : Iron and Steel - Classification of flat rolled products - Clarification regarding. Reference Board's Circular No. 20/89 dated the 26th May, 1989 on the above subject clarifying that flat rolled products which do not conform entirely to the dimensions specified in Note 1(k) to Chapter 72 would not be classifiable as flats under sub-heading 7211.11, and to say that suggestions have continued to .....

X X   X X   Extracts   X X   X X

→ Full Text of the Document

X X   X X   Extracts   X X   X X

..... section) other than rectangular or square, this stipulation would be attracted only if the products was covered by the definition of flat rolled products. The matter was therefore again taken up for discussion in the 2nd North Zone Tariff-cum-General Conference held at Manali on 7th and 8th June, 1990 where it was decided that further action should be taken after seeing samples of various product .....

X X   X X   Extracts   X X   X X

→ Full Text of the Document

X X   X X   Extracts   X X   X X

..... aid down in Note 1(k) to Chapter 72 as are of a shape other than rectangular or square. (c) If a product is not covered by the definition of flat rolled products the stipulation in Note 1(k) to Chapter 72 would not be attracted. These products would be more appropriately classified in terms of Note 1 (m) to Chapter 72 as other bars or rods under Heading 7214 or 7215 as the case may be. 5. Fiel .....

X X   X X   Extracts   X X   X X

→ Full Text of the Document

X X   X X   Extracts   X X   X X